MOBILE AUTO

Description

Can be controlled through IVRS
Users can call from their authorized number and can control and command through DTMF.

Easy to configure
Users can change every parameter such as (add user, set slot, set limits) via simple SMS command.

Easy to install
Users can easily connect it to their starter unit with the help of a simple wiring diagram.

1-year warranty *
This unit comes with a 1-year warranty(warranty voids in case of damage done by circuit burn or thunder)

Supports auto mode operation
In this mode motor will automatically start(if there is no phase fault) and will notify the user through call or message or both.

Supports timer mode operation
In this mode motor will start(if there is no phase fault) according to schedule(there are 4 slots available) set by the user and will notify the user by Message.

Maximum 10 users can  register

Prevents motor against these faults

1. Overvoltage (phase fault)
The unit continuously monitors the voltage of the supply and if it goes above the limit set by user it stops the motor and gives notification to the user through call or message or both.

2. Under-voltage (phase fault)
The unit continuously monitors the voltage of the supply and if it goes below the limit set by user it stops the motor and gives notification to the user through call or message or both.

3. Phase imbalance (phase fault)
The unit continuously monitors the voltage of 3 phase supply and if the voltage difference between two-phase goes beyond the limit set by user it stops the motor and gives notification to the user through call or message or both.

4. Phase reverse (in case of 3 phase supply)
After the power-on unit will check against phase sequence if the sequence is not proper it will not start the motor in any case thus preventing the motor from reverse rotation.

5. Overcurrent(overload)
The unit continuously monitors the current and if it goes above the limit set by user it stops the motor and gives notification to the user through call or message or both.

6. Under current (dry run)
The unit continuously monitors the current and if it goes below the limit set by user it stops the motor and gives notification to the user through call or message or both.

7. Technical fault (wire cut)
The unit continuously monitors the current and if current drops to zero it stops the motor and gives notification to the user through call or message or both.

Download PDF